AMT Datasouth Fastmark M4 Series Uživatelská příručka stáhnout pdf (Strana 30)

~ 30 ~

Printer initialization

Printer initialization is used to clear DRAM and restore printer settings to defaults.

1. Turn off the printer power switch.

2. Hold on the FEED button ( ) then turn on the power switch ( ).

3. Release the power switch ( ) when LED color turn on amber,

continue pressing the FEED button.

4. The printer will beep twice, then release the FEED ( ) button when the

battery LED indicates and blinking. The LED will sequence

right to left, 5 blinks each.

5. The printer will restore printer settings to defaults

Self-test and Dump Mode

Follow the steps below to calibrate the media sensor.

1. Turn off the printer power switch.

2. Hold on the FEED button ( ) then turn on the power switch ( ).

3. Release the power switch ( ) when LED color turn on amber,

continue pressing the FEED button.

4. The printer will beep twice, then release the FEED ( ) button when the

battery LED indicates and blinking. The LED will sequence

right to left, 5 blinks each.

5. The printer will calibrate the sensor and print out the internal settings,

then enter the DUMP mode. Turn the printer OFF/ON to exit DUMP

mode.

Power-ON Utility for standard panel

Follow the steps below for different power-ON utilities.

1. Turn off the printer power switch.

2. Press down the FEED button ( ) then turn on the power switch ( ).

3. Release the power switch ( ) when “Error” LED turns to red, continue

pressing the FEED button.

(With LCD Display)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 61 62

Žádné komentáře

AMT Datasouth Fastmark M4 Series Uživatelská příručka Strana 30