AMT Datasouth Fastmark M5 Plus Series Uživatelská příručka stáhnout pdf (Strana 9)

Document #120522 Rev-A

3.2 Setting Up the Printer

1. Place the printer on a flat, secure surface.

2. Make sure the power switch is off.

3. Connect the printer to the computer with the Centronics or USB cable.

4. Plug the power cord into the power supply connector at the rear of the

printer, and then plug the power cord into a properly grounded receptacle.

Fig. 3 Attach power supply to printer

3.3 Loading the Ribbon

The printer will detect if the ribbon is installed after turning the power on and it will

set printing mode to thermal transfer or direct thermal printing mode automatically.

If the printer does not detect the ribbon, the ribbon take up motor will be turned off.

Power Supply

Plug

Power Cable

Power Switch

USB

RS-232C

Centronics

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

Žádné komentáře

AMT Datasouth Fastmark M5 Plus Series Uživatelská příručka Strana 9