AMT Datasouth Fastmark M1 Uživatelská příručka stáhnout pdf (Strana 406)

Supported Printers and Drivers

Label Options Section

Print Speed

The range of available print speed varies with the selected printer

type.This setting controls the speed at which the stock moves

when printing. The combinations of print speed and head

temperature control the print quality of the label.

Slew Rate

This setting affects the speed at which the paper is fed when

advancing over non-printing areas.This setting may affect printer

throughput.

Backup Speed

This controls the rate of label movement during backup

positioning for start of print, cutting, or present distance.

Head Temperature

This allows you to control the darkness of the print. 10 is

nominal; setting the temperature higher than 10 causes the label

to print darker. Temperature settings lower than 10 cause the

label to print lighter.

Label Overrides Section

This section contains options used for Cutters, Label Presentation, and Symbol

Sets.

Advanced Options Section

Symbol Set

The Symbol Set option selects the scaleable font’s symbol

set.Consult the appendix section of your printer manual for a

description of the character set.

Double-byte Symbol

Set

This option allows you to choose a variety of Double-byte symbol

sets, if your printer has the capability.

Clear Memory Module

When checked, the memory module is cleared each time a label

format is sent.If unchecked, the memory module is not cleared

before each label format is sent, thus potentially saving time. This

option should only be used if enough memory is present to allow

the module to remain uncleared when a format is sent.

Override Printer Setup

When checked, this allows you to override the Clear Memory

setting in the PSO. This may be useful if you have a label that uses

a lot of memory, and clearing the memory module is important.

WARNING! Printing Blank Labels? If you are printing labels in thermal transfer mode, and blank labels are

advancing out of the printer, try increasing the head temperature in Label Options (F5) and test print your label

again.This symptom may occur if the ribbon being used requires hotter head temperatures to transfer the ink

from the ribbon onto the paper substrate.

Datamax Printer Specific Options

Printer Specific Options (PSOs) can be accessed by clicking on Options while configuring the printer or

by selecting the printer from the Device Configuration grid and clicking Options.

Loftware Label Manager Version 10.1.1 User's Guide

406

1 2 ... 401 402 403 404 405 406 407 408 409 410 411 ... 531 532

Komentáře k této Příručce

Žádné komentáře

AMT Datasouth Fastmark M1 Uživatelská příručka Strana 406

Komentáře k této Příručce