AMT Datasouth Fastmark M1 Uživatelská příručka stáhnout pdf (Strana 416)

100

101

Supported Printers and Drivers

Print Adjustment Section

Coordinat

e /

Coordinat

These values are measured in dots. This command is used to move the reference point for the X and Y-

axes. The reference point command functions similarly to the Label Home command found in File |

Media Setup. Default reference points vary depending upon whether the selected print direction is top

or bottom.

Gap

Length

The space in between labels. When printing on continuous stock, this setting can be used to add space

between printed labels.

Offset

Length

This is a setting found on Butterfly Labels. It sets the length between the top edge of the label, and the

indented portion of the label. The Offset Length is set in dots per inch.

Media

Feed

Adjustme

The amount of stock to advance after printing measured in dots.

Send

Media

Feed

Adjustme

Sets whether or not the Media Feed Adjustment is sent to the printer.

Options Section

Set

Label

Width

This command should be set on when labels narrower than the print head are printed. If the label width

equals the print head width, you may leave Set Label Width off and the printer automatically centers the

printing of the label.

Tear

Off

Mode

The tear off mode is the default mode.

Form

Backup

This command instructs the printer to retract the label before printing.

Sensor

Reverse

This option reverses the Through Sensor Operation, which interprets a blockage of light as a gap. This

option allows the through sensor to be used when printing transparent labels with a black stripe backing.

Dispen

Sensor

When enabled, the printer presents each label and waits for the label to be removed before continuing.

On the P2242 printer, the feed button must be pressed to print the next label. Available on Orion, Strata,

and P2242 only.

Dispen

se Tap

When enabled, the printer presents each label and waits for the feed switch to be pressed before printing

the next label. This mode is commonly used when printing multiple copies of liner-free labels. Available

only on the P2242.

Batch

Print &

Cut

When enabled, this option uses the Print Quantity and Copies values to control the cutter operations.The

cut instruction is executed when a batch of jobs has completed printing.

Loftware Label Manager Version 10.1.1 User's Guide

416

1 2 ... 411 412 413 414 415 416 417 418 419 420 421 ... 531 532

Komentáře k této Příručce

Žádné komentáře

AMT Datasouth Fastmark M1 Uživatelská příručka Strana 416

Komentáře k této Příručce